Este informe contiene informacion
muy importante sobre la calidad de su agua beber. Traduscalo
o hable con alguien que lo entienda bien.
We
are pleased to present this year's Annual Water Quality Report (Consumer
Confidence Report) as required by the Safe Drinking Water Act (SDWA). This
report is designed to provide details about where your water comes from, what
it contains, and how it compares to standards set by regulatory agencies. This
report is a snapshot of last year's water quality. We are committed to
providing you with information because informed customers are our best allies.
Last year, we conducted tests for over 80 contaminants. We only detected 12 of
those contaminants and found only 2 at a level higher than the EPA allows. As
we informed you at the time, our water temporarily exceeded drinking water
standards. (For more information see the section labeled Violations at the end
of the report.)
Some
people may be more vulnerable to contaminants in drinking water than the
general population. Immuno-compromised persons such as persons
with cancer undergoing chemotherapy, persons who have
undergone organ transplants, people with HIV/AIDS or other immune system
disorders, some elderly, and infants can be particularly at risk from
infections. These people should seek advice about drinking water from their
health care providers. EPA/Centers for Disease Control (CDC) guidelines on
appropriate means to lessen the risk of infection by Cryptosporidium and other
microbial contaminants are available from the Safe Water Drinking Hotline
(800-426-4791).
Your
drinking water comes from two deep ground water wells located in the Lower Rio
Grande Aquifer
If
you would like to learn more about source water assessment, please contact the
New Mexico drinking Bureau at (505) 476-8620 or toll free 1-877-654-8720.
Drinking water, including bottled water, may reasonably be expected to contain
at least some small amounts of contaminants. The presence of contaminants does
not necessarily indicate that water poses a health risk. More information about
contaminants and potential health effects can be obtained by calling the
Environmental Protection Agency's (EPA) Safe Drinking Water Hotline
(800-426-4791). The sources of drinking water (both tap water and bottled
water) include rivers, lakes, streams, ponds, reservoirs, springs, and wells.
As water travels over the surface of the land or through the ground, it
dissolves naturally occurring minerals and, in some cases, radioactive
material, and can pick up substances resulting from the presence of animals or
from human activity: microbial contaminants, such as viruses and bacteria, that
may come from sewage treatment plants, septic systems, agricultural livestock
operations, and wildlife; inorganic contaminants, such as salts and metals,
which can be naturally occurring or result from urban stormwater runoff,
industrial, or domestic wastewater discharges, oil and gas production, mining,
or farming; pesticides and herbicides, which may come from a variety of sources
such as agriculture, urban stormwater runoff, and residential uses; organic
Chemical Contaminants, including synthetic and volatile organic chemicals,
which are by-products of industrial processes and petroleum production, and can
also come from gas stations, urban stormwater runoff, and septic systems; and
radioactive contaminants, which can be naturally occurring or be the result of
oil and gas production and mining activities. In order to
ensure that tap water is safe to drink, EPA prescribes regulations that limit
the amount of certain contaminants in water provided by public water systems.
Food and Drug Administration (FDA) regulations establish limits for
contaminants in bottled water which must provide the same protection for public
health.
Lower
Rio Grande PWWA Board of Directors meet every third Wednesday of the month at
9:00 am. Locations are available on our website.
Your
water is treated by disinfection. Disinfection involves the addition of
chlorine or other disinfectant to kill dangerous bacteria and microorganisms
that may be in the water. Disinfection is considered to be one of the major
public health advances of the 20th century.
The purpose of this survey
is to determine whether a cross-connection may exist at your home or business.
A cross connection is an unprotected or improper connection to a public water
distribution system that may cause contamination or pollution to enter the
system. We are responsible for enforcing cross-connection control regulations
and insuring that no contaminants can, under any flow conditions, enter the
distribution system. If you have any of the devices listed below please contact
us so that we can discuss the issue, and if needed, survey your connection and
assist you in isolating it if that is necessary.
Protection of drinking
water is everyone's responsibility. You can help protect your community's
drinking water source in several ways:
The
system inventory does not include lead service lines. The Lower Rio Grande PWWA
High Valley inventory does not include lead service lines. We completed the
required report but there were some connections with unknown pipe composition.
We are working on identifying these unknown connections. Due to system meter
change outs all services were PVC.
Lead can cause serious health problems, especially for pregnant women and young
children. Lead in drinking water is primarily from materials and components
associated with service lines and home plumbing. Lower Rio Grande PWWA High
Valley is responsible for providing high quality drinking water and removing
lead pipes, but cannot control the variety of
materials used in plumbing components in your home. You share the
responsibility for protecting yourself and your family from the lead in your
home plumbing. You can take responsibility by identifying and removing lead
materials within your home plumbing and taking steps to reduce your family’s
risk. Before drinking tap water, flush your pipes for several minutes by
running your tap, taking a shower, doing laundry or a load of dishes. You can
also use a filter certified by an American National Standards Institute
accredited certifier to reduce lead in drinking water. If you are concerned
about lead in your water and wish to have your water tested, contact Lower Rio Grande PWWA High
Valley (Public Watersystem Id: NM3513107) by calling 575-233-3947 or emailing
Mike.Lopez@lrgauthority.org. Information on lead in drinking water, testing
methods, and steps you can take to minimize exposure is available at http://www.epa.gov/safewater/lead.
In order
to ensure that
tap water is safe to drink, EPA prescribes regulations which limit the amount
of contaminants in water provided by public water systems. The table below
lists all of the drinking water contaminants that we
detected during the calendar year of this report. Although many more
contaminants were tested, only those substances listed below were found in your
water. All sources of drinking water contain some naturally occurring
contaminants. At low levels, these substances are generally not harmful in our
drinking water. Removing all contaminants would be extremely expensive, and in
most cases, would not provide increased protection of public health. A few
naturally occurring minerals may actually improve the
taste of drinking water and have nutritional value at low levels. Unless
otherwise noted, the data presented in this table is from testing done in the
calendar year of the report. The EPA or the State requires us to monitor for certain
contaminants less than once per year because the concentrations of these
contaminants do not vary significantly from year to year, or the system is not
considered vulnerable to this type of contamination. As such, some of our data,
though representative, may be more than one year old. In this table you will
find terms and abbreviations that might not be familiar to you. To help you
better understand these terms, we have provided the definitions below the
table.
|
Contaminants |
MCLG |
MCL, |
Detect In |
Range |
Sample |
Violation |
Typical Source |
|
|
Low |
High |
|||||||
|
Disinfectants
& Disinfection By-Products |
||||||||
|
(There
is convincing evidence that addition of a disinfectant is necessary for
control of microbial contaminants) |
||||||||
|
Chlorine (as Cl2) (ppm) |
4 |
4 |
0.7 |
0.4 |
0.7 |
2025 |
No |
Water additive used to control
microbes |
|
TTHMs [Total Trihalomethanes]
(ppb) |
NA |
80 |
2 |
NA |
NA |
2025 |
No |
By-product of drinking water
disinfection |
|
Inorganic
Contaminants |
||||||||
|
Arsenic (ppb) |
00 |
10 |
1 |
NA |
NA |
2024 |
No |
Erosion of natural deposits; Runoff
from orchards; Runoff from glass and electronics production wastes |
|
Barium (ppm) |
2 |
2 |
0.041 |
NA |
NA |
2024 |
No |
Discharge of drilling wastes; Discharge
from metal refineries; Erosion of natural deposits |
|
Fluoride (ppm) |
4 |
4 |
0.4 |
NA |
NA |
2025 |
No |
Erosion of natural deposits; Water
additive which promotes strong teeth; Discharge from fertilizer and aluminum
factories |
|
Nitrate [measured as Nitrogen]
(ppm) |
10 |
10 |
1 |
NA |
NA |
2025 |
No |
Runoff from fertilizer use;
Leaching from septic tanks, sewage; Erosion of natural deposits |
|
Radioactive
Contaminants |
||||||||
|
Alpha emitters (pCi/L) |
00 |
15 |
13.9 |
NA |
NA |
2023 |
Yes |
Erosion of natural deposits |
|
Radium (combined 226/228) (pCi/L) |
00 |
5 |
0.63 |
NA |
NA |
2023 |
No |
Erosion of natural deposits |
|
Uranium (ug/L) |
00 |
30 |
15 |
NA |
NA |
2023 |
No |
Erosion of natural deposits |
|
Contaminants |
MCLG |
AL |
Your 90% |
Range |
# Samples |
Sample |
Exceeds AL |
Typical Source |
|
|
Low |
High |
||||||||
|
Inorganic
Contaminants |
|||||||||
|
Copper - action level at consumer
taps (ppm) |
1.3 |
1.3 |
0.2 |
0.06 |
0.27 |
0 |
2023 |
No |
Corrosion of household plumbing systems;
Erosion of natural deposits |
|
Lead - action level at consumer
taps (ppb) |
00 |
15 |
2.1 |
0.9 |
2.6 |
0 |
2023 |
No |
Corrosion of household plumbing
systems; Erosion of natural deposits |
|
Violations
and Exceedances |
|
Asbestos-We received a violation on 7/18/2025 for failing to
collect an asbestos sample during the 2011-2013 compliance period. We collected the sample on 10/22/2020 and
returned to compliance. Alpha emitters |
|
Unit
Descriptions |
|
|
Term |
Definition |
|
ug/L |
ug/L : Number of micrograms of
substance in one liter of water |
|
ppm |
ppm: parts per million, or milligrams per liter (mg/L) |
|
ppb |
ppb: parts per billion, or micrograms per liter (µg/L) |
|
pCi/L |
pCi/L:
picocuries per liter (a measure of radioactivity) |
|
mrem/yr |
mrem/yr: millirems per year (a measure of radiation
absorbed by the body) |
|
NA |
NA: not applicable |
|
ND |
ND: Not detected |
|
NR |
NR: Monitoring not required but recommended. |
|
Important
Drinking Water Definitions |
|
|
Term |
Definition |
|
MCLG |
MCLG: Maximum Contaminant Level
Goal: The level of a contaminant in drinking water below which there is no
known or expected risk to health. MCLGs allow for a margin of safety. |
|
MCL |
MCL: Maximum Contaminant Level:
The highest level of a contaminant that is allowed in drinking water. MCLs
are set as close to the MCLGs as feasible using the best available treatment
technology. |
|
TT |
TT: Treatment Technique: A
required process intended to reduce the level of a contaminant in drinking
water. |
|
AL |
AL: Action Level: The
concentration of a contaminant which, if exceeded, triggers treatment or
other requirements which a water system must follow. |
|
Variances and Exemptions |
Variances and Exemptions: State or
EPA permission not to meet an MCL or a treatment technique under certain
conditions. |
|
MRDLG |
MRDLG: Maximum residual disinfection
level goal. The level of a drinking water disinfectant below which there is
no known or expected risk to health. MRDLGs do not reflect the benefits of
the use of disinfectants to control microbial contaminants. |
|
MRDL |
MRDL: Maximum residual
disinfectant level. The highest level of a disinfectant allowed in drinking
water. There is convincing evidence that addition of a disinfectant is
necessary for control of microbial contaminants. |
|
MNR |
MNR: Monitored Not Regulated |
|
MPL |
MPL: State Assigned Maximum
Permissible Level |
|
90th Percentile |
Compliance with the lead and
copper action levels is based on the 90th percentile lead and copper levels.
This means that the concentration of lead and copper must be less than or
equal to the action level in at least 90% of the samples collected. |
|
For
more information please contact: |
Contact Name: Michael Lopez
Address: PO Box 2646
ANTHONY, NM 88021
Phone: 575-233-3947